Features:

Remote wireless remote control, remote shutter release and effective distance of 100 meters (without interference Kongkuo land).

With 16 channels, and strong anti-interference

With wireless B gate and multi-shot (the camera need to set the appropriate function)

Micro-power design, using longer

Battery Installation:

Receiver: slide open the battery compartment on the back of the receiver, into a CR2 lithium battery (factory has been equipped)

Transmitter: Open the rear cover screw transmitter section 23A into the battery (the factory has been equipped)

Channel settings:

To turn off the receiver power

Plug the receiver and the camera connected, and open the camera and receiver power

Pressing the shutter switch on the transmitter, the light and the light flashes on the receiver line, you can work.

B shutter, the camera set B first door, press the red light emitters such as to put out the release button, and then automatically transferred to the receiver gate B state is required to lift the door B, then transmitter can be.

Continuous shooting, continuous shooting function first camera settings, press the red light to the transmitter to be off the release button, and then automatically transferred to the receiver Continuous state, need to lift the continuous shooting, and then transmitter can be.

Note:

Please use the provided battery

The battery will run out when flash is the phenomenon of leakage, should change the batteries

Do not connect the camera power turned on or remove the receiver under

In order to operate is not a problem, be sure to plug patch firmly.

Other performance parameters, please refer to the instructions.

Applicable models:

CANON EOS 1V；
CANON EOS 3；
CANON EOS 1D；
CANON EOS 1DS；
CANON EOS 1DS MAKE II；
CANON EOS 10D；
CANON EOS 20D；
CANON EOS 30D；
CANON EOS 5D，5D Mark II；
CANON EOS 50D；
CANON EOS 40D；